Power Supplies
Description
Applying to electric appliances:
To ensure proper efficiency the total load should not exceed 90% of the inverters continuous output power, and the start power of the load should not exceed the output surge power of the inverter.
Installation Connections - Using as a SINGLE Standalone Inverter
1. The Master/Slave switch MUST be set to MASTER. If the selection switch is set to the slave position, there will be no power output.
2. The positive and negative terminals on the inverter must be hooked to their respective positive and negative terminals on the battery. The larger the system the thicker the wires need to be. Use only appropriately rated fuse blocks or breakers inline with the positive cable. If you cannot feed the inverter with enough input power, then the output will be low or no output.
3. Switch on the inverter. If the LED indicator is green, it means the inverter is working properly. If the LED is red and you hear a beep, this means that the DC input voltage low or incorrect. Immediately turn off the inverter and check your connections.
4.Plug your appliance into the inverter, then switch the inverter on. A green light indicates that everything is working as it should. The inverter has soft-start function.
5.When in use if the alarm beeps the LED indicator will turn red, which means the inverter went into protection mode. Protection mode is an automatic shut down to help avoid damage from happening to the inverter. The number of beeps corresponds to a fault code, these inverters are smart as they tell you what is wrong. You can check the fault code in the & quot;Protection Features& quot; section below.
The parallel quantities in one system can be composed freely in the range of 10PCS, so you can
Stack 2 for 3,000W Continuous Max Power
Stack 3 for 4,500W Continuous Max Power
Stack 4 for 6,000W Continuous Max Power
Stack 5 for 7,500W Continuous Max. Power
Read More
Sun Gold Power Co.,Ltd
power inverter , solar panel , solar cell , wind turbine generator , wind / soalr charge controller , ups
Address: 13F Wangxiangtiancheng Building, Shingping Industrial, Longgang District, Shenzhen ,Guangdong China,
shenzhen, Guangdong
China, 518000
Tel: 0086 755-666-32091
Fax: 0086 755-666-32092
