Hardware & Tools
Description
Bridge Cam Weld Gauge for Excess weld metal
manufacturer: ROK International Industry Co.,Limited. (China)
Order No: WG-208
1. High quality stainless steel.
2. Highly polished and ground
3. easy to take
Angle of preparation, 0 to 60
Excess weld metal (capping size)
Depth of undercut
Depth of pitting
Fillet weld throat size
Fillet weld length
Misalignment (high-low)
Weld Gauge or Bridge Cam Gauge is a unique, versatile instrument for the inspection of welded surfaces and joints.
It measures angle of preparation, 0 to 60, excess weld metal ( capping size), depth of undercut, depth of pitting, fillet weld throat size, fillet leg length, misalignment ( high-low), and linear measurements up to 60mm or 2 inches.
It measures in both inch or millimeters.
It is easy to use. It comprising of one rotating dial and one sliding pointer. Move the dial or pointer until it makes the appropriate contact and then read the result.
Scale reads in Inches and Millimeters.
Gage is placed on lower peice and dial rotated until it contacts higher piece
Small sliding pointer reads to 20mm and 3/4.
Gage also fits flush in 90 corners.
Scale reads 0 to 60 in 5 increments.
Angle is read against the chamfered edge of the dial
Methods of weld testing and analysis are used to assure the quality and correctness of the weld after it is completed. This term generally refers to testing
Read More
Rok International Industry Co.,Limited
inside micrometer, digital indicator, welding gauge
Address: 703D, Haosheng Industrial zone,
Shenzhen, Guangdong
China, 518052
Tel: 8675586172929
Fax: 8675586172929
