Active Components
Cat5e / Cat6 HDMI Signal Extender Power Over Ethernet Bidirectional Infrared Control
D - E70
Description
HDMI Extender over Single Cat5e / Cat6 HDMI Signal Extender With HD BaseT support POE function
?
Introduction :
?
The cat5e / cat6 HDMI Extender is a tool which can extend your HDMI signal over 230fts / 70meters to a compatible display . It is designed to convert HDMI signal to standard HD BaseT signal which can be transmitted by Internet cable . It also supports Transfer Bidirectional Infrared control signal together with the HDMI signal , so you can control the Source in the Sink side which is 230fts outside , also you can control the Sink in the Source side which is 230fts outside using the HDMI Extender .
?
Features :
?
1 . POE ( Power Over Ethernet ) function is supported, either TX or RX is powered by24V @ 1A power supply , another does not need power from the DC jack . POE Power consumption is less than 10W . - See the description 1 .
2 . Use single UTP LAN cable ?( CAT - 5E / 6 ) to substitute HDMI cable to achieve long distance transmission .
3 . UTP cable termination follows the standard of IEEE - 568B .
4 . Transmission distance : Over CAT6 cable .
? ? 70 meters : 1080P @ 60Hz36bit ; 3D1080P @ 30Hz36bit ;
? ? 40 meters : 1080P @ 60Hz @ 48bit ; 1080P @ 120Hz @ 24bit ;?
? ? 3D1080P @ 60Hz @ 36bit ; 4K x 2K @ 30Hz @ 24bit .
5 . Support display resolutions up to 4K x 2K @ 30Hz .
6 . Full HD support :?1080p @ 60Hz @ 48 bit / pixels , 1080p @ 120Hz @ 24 bit / pixels ,?3D 1080P60Hz and 4K x 2K @ 30Hz @ 24bit .
7 . Transfer Bidirectional Infrared control signal together with the HDMI signal . - See the description 2?.
?
Specifications :
?
- - - -
# Frequency Bandwidth | # 297MHz ?[ 10 . 2Gbps ] |
# Transmitter Input / Output Ports | # 1 x ?HDMI Female port ?/ 1 x ?CAT6 |
# 1 x ?IRTx / 1x?IR Rx |
# Receiver Input / Output Ports | # 1 x HDMI Female port / 1 x CAT6 |
# 1 x IR Tx / 1xIR Rx |
# Power Supply | # DC 24V 1A |
# ESD Protection | # ± 8kV ( air - gap discharge ) |
# Human Body Model : | # ± 4kV ( contact discharge ) |
# Dimensions ( mm ) | # 65 ( W ) ?X 100 ( D ) X 25 ( H ) |
# Weight | # 200g x 2 |
# Operating Temperature | # 0°C ~ 40°C / 32°F ~ 104°F |
# Storage Temperature | # - 20°C ~ 60°C / -4°F ~ 140°F |
# Relative Humidity | # 20 ~ 90 % RH ( Non - condensing ) |
# Power Consumption ( Max ) | # 10W |
- - - -
?
Operation controls and Functions
Transmitter
?
?
- - - -
# ?DC IN | # Plug the 24V DC power supply into the unit |
# IR OUT | # Channel 1 IR Transmitter. Connect with Wideband IR Tx |
# ?IR IN | # Channel 2 IR Receiver . Connect with Wideband IR Rx |
# HDMI IN | # HDMI input port. This slot is where you connect the HDMI source |
# HD BaseT OUT | # Standard HD BaseT signal output port . Connect HD BaseT receiver with a UTP cable following the standard of IEEE - 568B |
# ?LINK LED | # The connection status indicating lamp |
- - - -
?
Note:
# Illuminate : The Transmitter and Receiver are in good connections
# Flashing : The Transmitter and Receiver are in poor connections
# Dark : The Transmitter and Receiver are in no connections
Receiver
?
?
- - - -
# ?DC IN | # Plug the 24V DC power supply into the unit |
# IR OUT | # Channel 2 IR Transmitter. Connect with Wideband IR Tx |
# ?IR IN | # Channel 1 IR Receiver. Connect with Wideband IR Rx |
# HDMI OUT | # HDMI output port. This slot is where you connect the HDTV or monitor with HDMI cable |
# HD BaseT IN | # Standard HD BaseT signal input port . Connect HD BaseT transmitter with a UTP cable following the standard of IEEE - 568B |
# LINK LED | # The connection status indicating lamp |
- - - -
?
Note:
# Illuminate : The Transmitter and Receiver are in good connections
# Flashing : The Transmitter and Receiver are in poor connections
# Dark : The Transmitter and Receiver are in no connections
Description 1
?
POE ( Power Over Ethernet ) Application Example
?
?
Description 2
?
Bidirectional Infrared control Application Example
?
?
Application Example
?
?
Package
?
- - - -
# HDMI Extender Transmitter | # 1PCS |
# HDMI Extender Receiver | # 1PCS |
# Wideband IR Tx | # 2PCS |
# Wideband IR Rx | # 2PCS |
# 24V1A DC Power Supply | # 1PCS |
# Operation Manual | # 1PCS |
# Mounting ears | # 4PCS |
- - - -
?
Read More
SZ DODONET TECHNOLOGY CO.,LTD
VGA Video Converter,HDMI Switch Box,HDMI Signal Splitter
Address: 3rd floor ,Xinbaoyi electronic park ,Houting the third tech park ,Shajing town,Bao'an district ,Shenzhen ,China,
Shenzhen, Guangdong
China, 518000
Tel: 86-137-14429421
Fax: 86-137-14429421
