Pumps & Vacuum Equipment
Description
1.5-1 H Slurry pump
1) Total Net Weight— 91kg(high chrome type)/77kg(rubber type)
2) Shaft seal— Packing seal, Expeller seal, Mechanical seal
3) Frame Weight: 24Kg
4) Seal Water Capacity: 0.25l/s
Wetted Parts
Liners – Hard metal liners are completely interchangeable with pressure molded elastomer. Elastomer seal rings back all liner joints. Easily replaceable liners are bolted, not glued, to the casing for positive attachment and east of maintenance.
Impeller – Hard metal and molded elastomer impellers are completely interchangeable. Front and rear shrouds have pump out vanes that reduce recirculation and seal contamination.
Throat bush – Hard metal and molded elastomer impellers are completely interchangeable. Wear is reduced and maintenance simplified by the use of tapered mating faces to allow positive accurate alignment during assembly and simple removal.
Shaft seal
Expeller Seal(Centrifugal Seal) – Available with low flow water flush or zero flow (grease lubricated) options to provide exceptional sealing where water introduction to the seal is intolerable or limited.
Stuffing Box – Gland sealing with packing and lantern ring.
Bearing assembly?- A large diameter shaft with short overhang minimizes deflection and contributes to long bearing life. Only four through bolts are required to hold the cartridge type housing in the frame.
Pump Casing – Casing halves of cast or ductile iron with external reinforcing ribs provide high operating pressure capabilities and an extra measure of safety.
Frame Base – A very robust one-piece frame cradles the cartridge type bearing and shaft assembly. An external impeller adjustment mechanism is provided below the bearing housing for easy adjustment of impeller clearance.
Read More
Libra Fluid Equipment Co., Ltd
slurry pump, slurry pump impeller, warman slurry pump , ah slurry pump
Address: Shijiazhuang High-Tech Industry Development Zone,
Shijiazhuang, Hebei
China, 050000
Tel: +8618932929727
Fax: +8618932929727
