Others

1. Home
2. Products
3. Electronic & Electrical
4. Others

Share us

insertion electromagnetic flowmeter

HK

Send Inquiry

Description

LD series insertion electromagnetic flowmeter used to measure the conductivity of the liquid, JGLD series insertion electromagnetic flowmeter suitable for measuring large-diameter pipe, insertion electromagnetic flowmeters are widely used in petroleum, chemical, metallurgical, power, paper, food , Water treatment and other industries。



Model:
HKLD series

Caliber: DN350 - DN2000
Accuracy:
± 1.5%Measurement standards ±1.0% Special measurements ± 0.5% High-precision measurements

Minimum conductivity :
5μs/cm

Measuring range :
Recommended range: 0.5m / s ~ 10m / s continuously adjustable
Maximum use of: 0.2m / s ~ 15m / s continuously adjustable

Medium temperature : -20- +150℃
Ambient temperature : -20- +60℃
Fluid pressure : ≤ 1.6MPa
Protection :
Sensors 　　Converter
IP67 　　　IP67
IP68 　　　IP67

Material:
Probe is made of 304 stainless steel, 316 stainless steel electrode material, insulation layer PTFE.

Electrical interface :
M20×1.5,1/2〞NPT

Display :
Standard double liquid crystal display, can display instantaneous and cumulative flow。

Power source:
220VAC 50HZ 24VDC

Explosion levels：
Exd[ia]iam ll CT5

Signal output：
1、Switch can be set: pulse output (up to 1000HZ）；
High / low flow alarm；
ATC alarm；
Indicate flow direction；
Failure alarm；
2、Current output :4-20mA output。

Configuration mode：
1、Through three key on-site manual configuration。
2、Field configuration by remote control。
3、Site through the configuration of the terminal。
Memory: EEPROM memory will not disappear, no battery save。

Read More